ONE HOLE PRODUCTS SLUG ACCURIZING KIT MODEL ITH007 (ITHACA)
SKU:
$16.00
$16.00
Unavailable
per item
This is the ONE HOLE PRODUCTS SLUG ACCURIZING KIT Model ITH007 for Ithaca pump slug shotguns with cantilever barrel. Made in the USA with T6061 aluminum. Kit comes with screws. Please refer to ordering & info page for more details.
>This Accurizing Kit part is for 1/8" gaps in between your cantilever and receiver.
> Important Notes:
> ITHACA OWNERS HAVE TO MEASURE THE CLEARANCE BETWEEN THE CANTILEVER AND THE TOP OF THE RECEIVER TO DETERMINE IF THIS MODEL FITS THEIR FIREARM.
> Model ITH007 is for flat bottom cantilevers
>The Model ITH007 may/will accommodate "EARLIER" style Remington 870 Wingmasters if their post factory D&T mounting holes were for the Ithaca Model 37 or Remington Model 760. The gap and location of the extending cantilever hovering over the D&T mounting holes will still come into concern like the Ithaca.
> Important Note: If the cantilever extends and hovers over the reward scope mounting hole this part will work. If your cantilever is of the shorter design then depending on where your scope mounting holes are located can be a factor. If the cantilever does not extend pass the reward mounting hole (like on Hastings barrels possibly) I can make a custom two or three hole mounting part for however far your cantilever hovers over the scope mounting hole pattern. You could also allow the kit to extend beyond the cantilever and just use the holes required. Brownings and Pardners have two and three hole mounting systems so it will be plenty strong.
FREE SHIPPING
> Important Notes:
> ITHACA OWNERS HAVE TO MEASURE THE CLEARANCE BETWEEN THE CANTILEVER AND THE TOP OF THE RECEIVER TO DETERMINE IF THIS MODEL FITS THEIR FIREARM.
> Model ITH007 is for flat bottom cantilevers
>The Model ITH007 may/will accommodate "EARLIER" style Remington 870 Wingmasters if their post factory D&T mounting holes were for the Ithaca Model 37 or Remington Model 760. The gap and location of the extending cantilever hovering over the D&T mounting holes will still come into concern like the Ithaca.
> Important Note: If the cantilever extends and hovers over the reward scope mounting hole this part will work. If your cantilever is of the shorter design then depending on where your scope mounting holes are located can be a factor. If the cantilever does not extend pass the reward mounting hole (like on Hastings barrels possibly) I can make a custom two or three hole mounting part for however far your cantilever hovers over the scope mounting hole pattern. You could also allow the kit to extend beyond the cantilever and just use the holes required. Brownings and Pardners have two and three hole mounting systems so it will be plenty strong.
FREE SHIPPING