ONE HOLE PRODUCTS SLUG ACCURIZING KIT MODEL REM002A18 (REMINGTON)
SKU:
$16.00
$16.00
Unavailable
per item
This is the ONE HOLE PRODUCTS ACCURIZING KIT REM002A18 for Remington pump shotguns with cantilever slug barrels. For gaps between the receiver and bottom of cantilever of 1/8". Made in the USA with T6061 aluminum. Further info on this kit for your gun is available on the ordering & info page.
> Important Note:
NOTE: REMINGTON OWNERS HAVE TO MEASURE THE CLEARANCE BETWEEN THE
CANTILEVER AND THE TOP OF THE RECEIVER TO DETERMINE THE MODEL FOR THEIR
FIREARM. REMINGTON OWNERS SHALL MEASURE THEIR HOLE PATTERNS. THIS IS TO
PREVENT MISORDERING AND RETURNS OF INCORRECT MODEL ON REMINGTONS.
> The chuck end of a 1/8, 3/16, 1/4 "drill bit can be used to measure the gap closely. If it is a
little loose the screws will tighten the cantilever down, if the drill bit is a little snug the
cantilever will flex slightly to accommodate the Kit. Feeler gages will work also. If these drill
bits are way loose or tight I possibly could make a custom one for you. For instance if a 5/32" or 7/32"
drill goes in between the the gap just right. There are different models for different gaps.
> This is the most general Remington shotgun scope hole pattern, but there are a few
others since Remington's multiple company changes.
REMINGTONS WITH THIS HOLE PATTERN
PLUS SIGNS REPRESENT HOLE CENTERS
+ ---1 13/32”--- + ---1 15/32”--- + ---1 13/32”--- +
FREE SHIPPING
NOTE: REMINGTON OWNERS HAVE TO MEASURE THE CLEARANCE BETWEEN THE
CANTILEVER AND THE TOP OF THE RECEIVER TO DETERMINE THE MODEL FOR THEIR
FIREARM. REMINGTON OWNERS SHALL MEASURE THEIR HOLE PATTERNS. THIS IS TO
PREVENT MISORDERING AND RETURNS OF INCORRECT MODEL ON REMINGTONS.
> The chuck end of a 1/8, 3/16, 1/4 "drill bit can be used to measure the gap closely. If it is a
little loose the screws will tighten the cantilever down, if the drill bit is a little snug the
cantilever will flex slightly to accommodate the Kit. Feeler gages will work also. If these drill
bits are way loose or tight I possibly could make a custom one for you. For instance if a 5/32" or 7/32"
drill goes in between the the gap just right. There are different models for different gaps.
> This is the most general Remington shotgun scope hole pattern, but there are a few
others since Remington's multiple company changes.
REMINGTONS WITH THIS HOLE PATTERN
PLUS SIGNS REPRESENT HOLE CENTERS
+ ---1 13/32”--- + ---1 15/32”--- + ---1 13/32”--- +
FREE SHIPPING